Mazda 2: Conventional Brake System
CONVENTIONAL BRAKE SYSTEM LOCATION INDEX

- Vacuum line
- (See VACUUM LINE INSPECTION.)
- (See VACUUM HOSE REMOVAL/INSTALLATION.)
- Brake fluid
- (See BRAKE FLUID INSPECTION.)
- (See BRAKE FLUID AIR BLEEDING.)
- Power brake unit
- (See POWER BRAKE UNIT INSPECTION.)
- (See POWER BRAKE UNIT REMOVAL/INSTALLATION.)
- Brake pedal
- (See BRAKE PEDAL INSPECTION.)
- (See BRAKE PEDAL REMOVAL/INSTALLATION.)
- Brake switch
- (See BRAKE SWITCH INSPECTION [MTX].)
- (See BRAKE SWITCH INSPECTION [ATX].)
- Rear brake (drum)
- (See REAR BRAKE (DRUM) INSPECTION.)
- (See REAR BRAKE (DRUM) REMOVAL/INSTALLATION.)
- (See WHEEL CYLINDER DISASSEMBLY/ASSEMBLY.)
- (See BRAKE HOSE (REAR) REMOVAL/INSTALLATION.)
- Front brake (disc)
- (See FRONT BRAKE (DISC) INSPECTION.)
- (See FRONT BRAKE (DISC) REMOVAL/INSTALLATION.)
- (See DISC PAD (FRONT) REPLACEMENT.)
- (See CALIPER (FRONT) DISASSEMBLY/ASSEMBLY.)
- (See BRAKE HOSE (FRONT) REMOVAL/INSTALLATION.)
- Master cylinder
- (See MASTER CYLINDER REMOVAL/INSTALLATION.)
- (See BRAKE FLUID LEVEL SENSOR INSPECTION.)
READ NEXT:
BRAKE FLUID INSPECTION
1. Verify that the brake fluid level in the reserve tank is between the MAX
and MIN marks.
If the brake fluid level is below the MIN mark, add brake fluid.
BRAKE FLUID AIR
BRAKE PEDAL INSPECTION
Pedal Height Inspection
1. Measure the distance from the steering shaft cover to the center of the
upper surface of
the pedal pad and verify that it is as specified.
If not
BRAKE SWITCH INSPECTION
CAUTION:
Inspect the brake switch with it installed to the brake pedal, otherwise
the brake switch
may not operate normally after inspection. If the brake switch is remove
SEE MORE:
LUBRICATION SYSTEM LOCATION INDEX
Dipstick
(See ENGINE OIL LEVEL INSPECTION)
(See ENGINE OIL REPLACEMENT)
Oil pressure switch
(See OIL PRESSURE INSPECTION)
Oil filter
(See OIL FILTER REPLACEMENT)
Oil strainer
(See OIL PAN REMOVAL/INSTALLATION)
Oil pan
(See OIL PAN
INTERMEDIATE SHAFT REMOVAL/INSTALLATION
WARNING:
The steering column (EPS motor) temperature increases directly after
continuous
turning of the steering mechanism which could cause burns if it is touched.
Before
performing any servicing, verify that the steering column has cooled off.
CAUTI
© 2016-2021 Copyright www.m2info.net