Mazda 2: Coil Antenna

COIL ANTENNA REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.

2. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION).

3. Disconnect the coil antenna connector.

Mazda 2. COIL ANTENNA REMOVAL/INSTALLATION

4. Detach the coil antenna hooks and remove the coil antenna from the steering lock.

5. Install in the reverse order of removal.

LIFTGATE OPENER SWITCH REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.

2. Remove the liftgate lower trim. (See LIFTGATE LOWER TRIM REMOVAL/INSTALLATION).

3. Disconnect the connector.

Mazda 2. LIFTGATE OPENER SWITCH REMOVAL/INSTALLATION

4. Pull out the retainer in the direction of the arrow.

5. Remove the liftgate opener switch.

Mazda 2. LIFTGATE OPENER SWITCH REMOVAL/INSTALLATION

6. Install in the reverse order of removal.

LIFTGATE OPENER SWITCH INSPECTION

1. Disconnect the negative battery cable.

2. Remove the liftgate lower trim. (See LIFTGATE LOWER TRIM REMOVAL/INSTALLATION).

3. Remove the liftgate opener switch. (See LIFTGATE OPENER SWITCH REMOVAL/INSTALLATION).

4. Verify the continuity of liftgate opener switch terminals A and B.

Mazda 2. LIFTGATE OPENER SWITCH INSPECTION

5. Verify that the continuity is as indicated in the table.

Mazda 2. LIFTGATE OPENER SWITCH INSPECTION

SECURITY ACCESS PROCEDURE

1. Connect the M-MDS (IDS) to the DLC-2.

2. After the vehicle is identified, select the following items from the initialization screen of the IDS.

  1. Select the "Body"
  2. Select the "Security"
  3. Select the "PATS Functions"

3. Then, select items from the screen menu in the following order.

4. Perform the security access according to the directions on the M-MDS screen.

READ NEXT:

 Exterior Trim

EXTERIOR TRIM LOCATION INDEX Cowl grille Sail garnish Roof molding Front beltline molding Splash shield Side step molding Mudguard Rear spoiler Rear door garnish Rear beltline molding Do

 Interior Trim

INTERIOR TRIM LOCATION INDEX Inner garnish Meter hood Ventilator grille Dashboard Dashboard under cover Glove compartment Lower panel Knee bolster Front side trim Headliner Trunk side

 Dashboard

DASHBOARD REMOVAL/INSTALLATION 1. Disconnect the negative battery cable. 2. Remove the following parts: Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION). Dashboard under cover (See D

SEE MORE:

 DTC B00D5:11/B00D5:12

System Malfunction Location Detection Condition WARNING: Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When p

 Head Restraints

Your vehicle is equipped with head restraints on front seats, rear outboard seats* and the rear centre seat * . The head restraints are intended to help protect you and the passengers from neck injury. WARNING Always drive with the head restraints installed when seats are being used and make

© 2016-2022 Copyright www.m2info.net