Mazda 2: Child-Restraint System Suitability for Various Seat Positions Table

Mazda2 DJ 2014–2020 Owners Manual / Essential Safety Equipment / Child Restraint / Child-Restraint System Suitability for Various Seat Positions Table

(Europe and countries conforming to the UNECE 16 regulation)

Provided information in the table shows your child-restraint system suitability for various seating position. For installation suitability of other manufacturer child-restraint system, carefully consult the manufacturer's instructions which accompany the child-restraint system.

ISOFIX anchor-secured child-restraint systems

When installing a child-restraint system to the rear seat, refer to the child-restraint system manufacturer's instructions and the Using ISOFIX Anchor on page 2-37 .

ISOFIX anchor-secured child-restraint systems


  1. For the CRS which do not carry the ISO/XX size class identifi cation (A to G), for the applicable mass group, the car manufacturer shall indicate the vehicle specifi c ISOFIX child-restraint system(s) recommended for each position.

Key of letters to be inserted in the above table:

IUF = suitable for ISOFIX forward child-restraints systems of universal category approved for use in this mass group.

IL = suitable for particular ISOFIX child-restraint systems (CRS).

These ISOFIX CRS are those of the “specifi c vehicle”, “restricted” or “semi-universal” categories.

A Mazda genuine child-restraint system can be installed. Regarding child-restraint systems which can be installed, refer to the accessories catalog.

(Except Europe) Regarding child-restraint systems which can be installed to your Mazda, consult an expert repairer, we recommend an Authorised Mazda Repairer.

X = ISOFIX position not suitable for ISOFIX child-restraint systems in this mass group and/or this size class.

i-Size child-restraint systems

Vehicles with the mark indicated
on the front surface of a rear seatback are i-Size childrestraint certifi ed.

Marking location

Marking location


An i-Size child-restraint system can be installed to the specifi ed seat as follows:

An i-Size child-restraint system can be installed to the specifi ed seat as follows


Key of letters to be inserted in the above table: i-U = Suitable for i-Size “universal” child-restraint systems forward and rearward facing.

X = Seating position not suitable for i-Size “universal” child-restraint systems.

NOTE

Seat belt-secured child-restraint systems

When installing a child-restraint system, the following points must be observed:

Seat belt-secured child-restraint systems


Key of letters to be inserted in the above table: U = Suitable for “universal” category restraints approved for use in this mass group.

UF = Suitable for forward-facing “universal” category restraints approved for use in this mass group.

X = Seat position not suitable for children in this mass group.

(Other countries)

Please comply with the legal regulations concerning the use of child-restraint systems in your country.

READ NEXT:

 Installing Child-Restraint Systems

Anchor Bracket Anchor brackets for securing childrestraint systems are equipped in the vehicle. Locate each anchor position using the illustration. To install a child-restraint system, if the

 SRS Air Bags

 Supplementary Restraint System (SRS) Precautions

The front and side supplementary restraint systems (SRS) include up to 6 air bags. Please verify which kinds of air bags are equipped on your vehicle by locating the “SRS AIRBAG” location indi

SEE MORE:

 Cruise Control

With cruise control, you can set and automatically maintain any speed of more than about 25 km/h (16 mph). WARNING Do not use the cruise control under the following conditions: Using the cruise control under the following conditions is dangerous and could result in loss of vehicle control.

 Canister Vent (CV) Solenoid Valve

CANISTER VENT (CV) SOLENOID VALVE REMOVAL/INSTALLATION 1. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION). 2. Remove in the order indicated in the table. CV solenoid valve connector Evaporative hose Evaporative hose CV solenoid valve 3. Install in the reverse order

© 2016-2020 Copyright www.m2info.net