Mazda 2: Canister Vent (CV) Solenoid Valve

Mazda 2 2007-2014 Service Manual / Engine / Emission System / Canister Vent (CV) Solenoid Valve

CANISTER VENT (CV) SOLENOID VALVE REMOVAL/INSTALLATION

1. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION).

2. Remove in the order indicated in the table.

Mazda 2. CANISTER VENT (CV) SOLENOID VALVE

  1. CV solenoid valve connector
  2. Evaporative hose
  3. Evaporative hose
  4. CV solenoid valve

3. Install in the reverse order of removal.

Evaporative Hose Removal Note

1. Install the evaporative hose as shown in the figure.

Mazda 2. CANISTER VENT (CV) SOLENOID VALVE

CANISTER VENT (CV) SOLENOID VALVE INSPECTION

Airflow Inspection

1. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION).

2. Remove the CV solenoid valve. (See CANISTER VENT (CV) SOLENOID VALVE REMOVAL/INSTALLATION).

3. Inspect airflow between the ports under the following conditions.

Mazda 2. CANISTER VENT (CV) SOLENOID VALVE

Mazda 2. CANISTER VENT (CV) SOLENOID VALVE

AIR FILTER REMOVAL/INSTALLATION

1. Remove the splash shield (LH). (See SPLASH SHIELD REMOVAL/INSTALLATION).

2. Remove the fuel-filler pipe protector. (See FUEL TANK REMOVAL/INSTALLATION).

3. Remove in the order indicated in the table.

Mazda 2. AIR FILTER REMOVAL/INSTALLATION

  1. Evaporative hose
  2. Air filter

4. Install in the reverse order of removal.

READ NEXT:

 Ignition System

IGNITION SYSTEM LOCATION INDEX Ignition coil (See IGNITION COIL REMOVAL/INSTALLATION) (See IGNITION COIL INSPECTION) Spark plug (See SPARK PLUG REMOVAL/INSTALLATION) (See SPARK PLUG IN

 Charging System

CHARGING SYSTEM LOCATION INDEX Generator (See GENERATOR REMOVAL/INSTALLATION) (See GENERATOR INSPECTION) (See GENERATOR DISASSEMBLY/ASSEMBLY) Battery (See BATTERY REMOVAL/INSTALLATION)

 Starting System

STARTING SYSTEM LOCATION INDEX Starter interlock switch (MTX) (See STARTER INTERLOCK SWITCH INSPECTION) Starter (See STARTER REMOVAL/INSTALLATION) (See STARTER INSPECTION) (See STARTER

SEE MORE:

 Airflow Mode Link Set

AIRFLOW MODE LINK SET REMOVAL/INSTALLATION 1. Disconnect the negative battery cable. 2. Remove the following parts: Rear console (See REAR CONSOLE REMOVAL/INSTALLATION). Shift lever knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION). Side wall (See SIDE WALL REMOVAL/INSTALL

 Collection/Disposal of Old Equipment/Used Battery

Information for Users on Collection and Disposal of Old Equipment and Used Batteries When disposing your old battery, please refer to the information as follows. Information on Disposal in the European Union These crossed-out wheeled bin symbols on the products, packaging, and/or accompanying

© 2016-2021 Copyright www.m2info.net