Mazda 2: Camshaft Position (CMP) Sensor

Mazda 2 2007-2014 Service Manual / Engine / Control System / Camshaft Position (CMP) Sensor

CAMSHAFT POSITION (CMP) SENSOR REMOVAL/INSTALLATION

CAUTION:

1. Disconnect the negative battery cable.

2. Disconnect the CMP sensor connector.

3. Remove the CMP sensor.

Mazda 2. CAMSHAFT POSITION (CMP) SENSOR

4. Verify that the O-ring is not damaged.

5. Apply a small amount of clean oil to the O-ring and the cylinder head cover.

6. Install in the reverse order of removal.

CAMSHAFT POSITION (CMP) SENSOR INSPECTION

Visual Inspection

1. Remove the CMP sensor. (See CAMSHAFT POSITION (CMP) SENSOR REMOVAL/INSTALLATION).

2. Verify that there are no metal shavings on the sensor.

3. Install the CMP sensor. (See CAMSHAFT POSITION (CMP) SENSOR REMOVAL/INSTALLATION).

Voltage Inspection

CAUTION:

1. Idle the engine.

2. Measure the camshaft position signal and verify that rectangular waves are produced.

(See PCM INSPECTION).

3. If not as specified, replace the CMP sensor. (See CAMSHAFT POSITION (CMP) SENSOR REMOVAL/INSTALLATION).

READ NEXT:

 Knock Sensor (KS)

KNOCK SENSOR (KS) REMOVAL/INSTALLATION 1. Disconnect the negative battery cable. 2. Remove the intake manifold. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION). 3. Disconnect the KS connector. 4. Remo

 Fuel Tank Pressure Sensor

FUEL TANK PRESSURE SENSOR REMOVAL/INSTALLATION CAUTION: The fuel tank pressure sensor cannot be removed as a single unit. When replacing the fuel tank pressure sensor, replace it together with th

 Suspension

SEE MORE:

 Refrigerant System Service

REFRIGERANT SYSTEM SERVICE WARNINGS Handling Refrigerant Avoid breathing air conditioning refrigerant or lubricant vapor. Exposure may irritate eyes, nose and throat. Also, due to environmental concerns, we urge use of recovery/recycling/recharging equipment when draining R-134a from the air

 Foreword [Multiplex Communication System]

If the CAN system is considered to be the cause of the malfunction based on the repair order form and the malfunctioning symptom, follow the Troubleshooting Procedure. DTCs are also output due to a control module or sensor malfunction, or incorrect power supply. Verify the output DTCs and f

© 2016-2021 Copyright www.m2info.net