Mazda 2: Brake Switch

BRAKE SWITCH INSPECTION

CAUTION:

1. Verify that the continuity is as indicated in the table.

Mazda 2. BRAKE SWITCH INSPECTION

Mazda 2. BRAKE SWITCH INSPECTION

BRAKE SWITCH INSPECTION

CAUTION:

1. Measure the voltage between the following terminals and body ground and verify that the voltage is as indicated in the table.

Mazda 2. BRAKE SWITCH INSPECTION

Mazda 2. BRAKE SWITCH INSPECTION

Mazda 2. BRAKE SWITCH INSPECTION

READ NEXT:

 Master Cylinder

MASTER CYLINDER REMOVAL/INSTALLATION CAUTION: When removing/installing the master cylinder, avoid touching the primary piston with your hand when not necessary. Otherwise, it could damage the ma

 Power Brake Unit

POWER BRAKE UNIT INSPECTION NOTE: The following inspection methods are simple inspection methods to judge the function of the power brake unit. If there is any malfunction in the power brake uni

 Front Brake (Disc)

FRONT BRAKE (DISC) REMOVAL/INSTALLATION 1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. 3. Add brake fluid, bleed the brakes, and inspect for leakage after

SEE MORE:

 Positive Crankcase Ventilation (PCV)

POSITIVE CRANKCASE VENTILATION (PCV) VALVE REMOVAL/INSTALLATION 1. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION). 2. Remove the fresh-air duct and the air cleaner as a single unit. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION). 3. Remove the intake manifold and the fuel

 DTC B0001:11/B0001:12/B0001:13/B0001:19/B0001:1A

System Malfunction Location Detection Condition WARNING: Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When pe

© 2016-2022 Copyright www.m2info.net