Mazda 2: Brake/Clutch Fluid

Inspecting Brake/Clutch Fluid Level

WARNING

If the brake/clutch fl uid level is low, have the brakes inspected: A low brake/clutch fl uid level is dangerous.

A low level could indicate brake lining wear or a brake system leak which could cause the brakes to fail and lead to an accident.

The brakes and clutch draw fl uid from the same reservoir.

Inspect the fl uid level in the reservoir regularly. It should be kept between the MAX and MIN lines.

The level normally drops with accumulated distance, a condition associated with wear of brake and clutch linings. If it is excessively low, have the brake/clutch system inspected by an expert repairer, we recommend an Authorised Mazda Repairer.

Left-hand drive model

Left-hand drive model


Right-hand drive model

Right-hand drive model


READ NEXT:

 Window and Headlight Washer Fluid

Inspecting Washer Fluid Level WARNING Use only windscreen washer fl uid or plain water in the reservoir: Using radiator antifreeze as washer fl uid is dangerous. If sprayed on the windscreen, it

 Body Lubrication

All moving points of the body, such as door and bonnet hinges and locks, should be lubricated each time the engine oil is changed. Use a nonfreezing lubricant on locks during cold weather. Make

 Wiper Blades

CAUTION Hot waxes applied by automatic car washers have been known to affect the wiper's ability to clean windows. To prevent damage to the wiper blades, do not use petrol, paraffi n, paint thin

SEE MORE:

 DriveLine & Axle

GENERAL PROCEDURES (FRONT AND REAR AXLES) Wheel and Tire Installation 1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross pattern to the following tightening torque. Tightening Torque 88-118 N*m {9.0-12 kgf*m, 65-87 ft*lbf} Connector Disconnection 1. Disconnect t

 Wheel Alignment Pre-inspection

1. Park the vehicle on a level ground, in an unloaded condition*, and with the wheels straight forward. *: Unloaded condition.....Fuel tank is full. Engine coolant and engine oil are at specified level. Spare tire, jack and tools are in designated position. 2. Inspect the tire pressure. Adjus

© 2016-2021 Copyright www.m2info.net