Mazda 2 manuals

Mazda 2: Bonnet

Mazda2 DJ 2014–2020 Owners Manual / Maintenance and Care / Owner Maintenance / Bonnet

WARNING

Always check that the bonnet is closed and securely locked: A bonnet that is not closed and securely locked is dangerous as it could fl y open while the vehicle is moving and block the driver's vision which could result in a serious accident.

Opening the Bonnet

  1. With the vehicle parked, pull the release handle to unlock the bonnet.

Opening the Bonnet


  1. Insert your hand into the bonnet opening, slide the latch lever to the right, and lift up the bonnet.

Opening the Bonnet


  1. Grasp the support rod in the padded area and secure it in the support rod hole indicated by the arrow to hold the bonnet open.

Opening the Bonnet


Closing the Bonnet

  1. Check under the bonnet area to make certain all fi ller caps are in place and all loose items (e.g. tools, oil containers, etc.) have been removed.
  2. Lift the bonnet, grasp the padded area on the support rod, and secure the support rod in the clip. Verify that the support rod is secured in the clip before closing the bonnet.

Closing the Bonnet


  1. Lower the bonnet slowly to a height of about 20 cm (7.9 in) above its closed position and then let it drop.

CAUTION

When closing the bonnet, do not push it excessively such as by applying your weight. Otherwise, the bonnet could be deformed.

READ NEXT:

 Engine Compartment Overview

SKYACTIV-G 1.3 and SKYACTIV-G 1.5 SKYACTIV-D 1.5

 Engine Oil

NOTE Changing the engine oil should be done by an expert repairer, we recommend an Authorised Mazda Repairer. Recommended Oil In order to keep the maintenance interval (page 6-3 ) and to protect

 Engine Coolant

Inspecting Coolant Level WARNING Do not use a match or live fl ame in the engine compartment. DO NOT ADD COOLANT WHEN THE ENGINE IS HOT: A hot engine is dangerous. If the engine has been runnin

SEE MORE:

 Rear Oil Seal

REAR OIL SEAL REPLACEMENT 1. Remove the transaxle. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [FN4A-EL] (ATX) ). (See MANUAL TRANSAXLE REMOVAL/INSTALLATION [F35M-R] (MTX) ). 2. Remove the drive plate (ATX) or the flywheel (MTX). (See DRIVE PLATE REMOVAL/INSTALLATION [FN4A-EL] (ATX) ). (See CLUT

 Windscreen Wipers and Washer

The ignition must be switched ON to use the wipers. WARNING Use only windscreen washer fl uid or plain water in the reservoir: Using radiator antifreeze as washer fl uid is dangerous. If sprayed on the windscreen, it will dirty the windscreen, affect your visibility, and could result in an

© 2016-2020 Copyright www.m2info.net