Mazda 2: Body Lubrication
All moving points of the body, such as
door and bonnet hinges and locks, should
be lubricated each time the engine oil is
changed. Use a nonfreezing lubricant on
locks during cold weather.
Make sure the bonnet's secondary latch
keeps the bonnet from opening when the
primary latch is released.
READ NEXT:
CAUTION
Hot waxes applied by automatic car
washers have been known to affect
the wiper's ability to clean windows.
To prevent damage to the wiper
blades, do not use petrol, paraffi n,
paint thin
WARNING
Read the following
precautions carefully before using the battery or inspecting to
ensure safe and correct handling:
Always wear eye
protection when working near the battery:
Working w
If the buttons on the transmitter are
inoperable and the operation indicator
light does not fl ash, the battery may be
dead.
Replace with a new battery before the
transmitter becomes unusable.
SEE MORE:
System Malfunction Location
Seat weight sensor control module circuit open to power supply
Detection Condition
WARNING:
Detection conditions are for understanding the DTC outline before
performing an
inspection. Performing an inspection according to only the detection
conditions may
cause
HEAT DUCT COMPONENT REMOVAL/INSTALLATION
Heat Duct (LH)
1. Disconnect the negative battery cable.
2. Remove the following parts:
Rear console (See REAR CONSOLE REMOVAL/INSTALLATION).
Shift lever knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM
REMOVAL/INSTALLATION).
Side wall (See SIDE WALL R
© 2016-2021 Copyright www.m2info.net