Mazda 2: Automatic Transaxle Fluid (ATF)
AUTOMATIC TRANSAXLE FLUID (ATF) INSPECTION
Automatic transaxle Fluid (ATF) Condition Inspection
1. Remove the dipstick.
2. One way of determining whether the transaxle should be disassembled is by
noting:
- If the ATF is muddy or varnished.
- If the ATF smells strange or unusual.
ATF condition

Transaxle Fluid (ATF) Level Inspection
CAUTION:
- If the ATF level is not within the specification, do not drive the
vehicle. Otherwise, the
transaxle could be damaged.
- If there is no ATF adhering to the dipstick after warming up the engine,
there is
insufficient ATF. Therefore do not drive the vehicle as it could damage the
transaxle.
- If too much ATF is added, the ATF temperature will increase and oil
could leak from the
breather hose.
1. Park the vehicle on level ground, and then engage the parking brake and
use wheel chocks
at the front and rear of the wheels.
2. Verify visually that there is no ATF leakage from the oil hose or housing.
3. Connect the M-MDS to the DLC-2.
4. Start the engine and warm it up in the P position.
CAUTION:
- If the oil level decreases dramatically while warming-up the engine, do
not
shift the selector lever as it could damage the transaxle.
5. Verify that the ATF temperature is 60-70
READ NEXT:
TRANSAXLE RANGE (TR) SWITCH INSPECTION
CAUTION:
Water or foreign objects entering the connector can cause a poor
connection or
corrosion. Be sure not to drop water or foreign objects on the conne
TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR INSPECTION
CAUTION:
Water or foreign objects entering the connector can cause a poor
connection or
corrosion. Be sure not to drop water or foreign objects
INPUT/TURBINE SPEED SENSOR INSPECTION
CAUTION:
Water or foreign objects entering the connector can cause a poor
connection or
corrosion. Be sure not to drop water or foreign objects on the connec
SEE MORE:
The ignition must be switched ON to use
the turn and lane-change signals.
Direction Indicators
Move the signal lever down (for a left
turn) or up (for a right turn) to the stop
position. The signal will self-cancel after
the turn is completed.
If the indicator light continues to fl ash
aft
KNOCK SENSOR (KS) REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the intake manifold. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION).
3. Disconnect the KS connector.
4. Remove the KS using the SST
5. Install in the reverse order of removal.
KNOCK SENSOR (KS) INSPECTION
1.
© 2016-2022 Copyright www.m2info.net
