Mazda 2: Air Filter

AIR FILTER REMOVAL/INSTALLATION

CAUTION:

1. Remove in the order indicated in the table.

Mazda 2. AIR FILTER REMOVAL/INSTALLATION

  1. Air filter cover
  2. Air filter (2)
  3. Air filter (1)

2. Install in the reverse order of removal.

Air Filter Installation Note

NOTE:

Mazda 2. AIR FILTER REMOVAL/INSTALLATION

1. Insert the air filter (1) projection so that it fits into the groove on the rear surface of the A/C unit case.

Mazda 2. AIR FILTER REMOVAL/INSTALLATION

2. Slide the air filter (1) in the upward direction and hold.

Mazda 2. AIR FILTER REMOVAL/INSTALLATION

3. Insert the air filter (2) projection so that it fits into the groove on the lower side of the A/C unit case.

Mazda 2. AIR FILTER REMOVAL/INSTALLATION

AIR FILTER INSPECTION

1. Inspect for damage, excessive dirt, or foul smell.

NOTE:

EVAPORATOR INSPECTION

1. Remove the A/C unit. (See A/C UNIT REMOVAL/INSTALLATION).

2. Remove the evaporator from the A/C unit.

3. Inspect for cracks, damage, and oil leakage.

4. Inspect for bent fins.

HEATER CORE INSPECTION

1. Remove the A/C unit. (See A/C UNIT REMOVAL/INSTALLATION).

2. Remove the heater core from the A/C unit.

3. Inspect for cracks, damage, and coolant leakage.

4. Inspect for bent fins.

5. Verify that the heater core inlet and outlet pipe are not distorted or damaged.

READ NEXT:

 Airflow Mode Link Set

AIRFLOW MODE LINK SET REMOVAL/INSTALLATION 1. Disconnect the negative battery cable. 2. Remove the following parts: Rear console (See REAR CONSOLE REMOVAL/INSTALLATION). Shift lever knob (MTX) (Se

 Heat Duct Component

HEAT DUCT COMPONENT REMOVAL/INSTALLATION Heat Duct (LH) 1. Disconnect the negative battery cable. 2. Remove the following parts: Rear console (See REAR CONSOLE REMOVAL/INSTALLATION). Shift lever k

 A/C Compressor

A/C COMPRESSOR REMOVAL/INSTALLATION 1. Disconnect the negative battery cable. 2. Remove the splash shield (RH). 3. Collect the refrigerant. (See REFRIGERANT CHARGING). 4. Remove the drive belt. (Se

SEE MORE:

 DTC B10FD:11/B10FD:13/B10FD:87/B10FD:96

System Malfunction Location Detection Condition WARNING: Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection according to only the detection conditions may cause injury due to an operating error, or damage the system. When p

 Rear Window Defogger

The rear window defogger clears fog from the rear window. The ignition must be switched ON to use the defogger. Press the switch to turn on the rear window defogger. The rear window defogger operates for about 15 minutes and then turns off automatically. The indicator light illuminates

© 2016-2021 Copyright www.m2info.net