Mazda 2: Add-On Non-Genuine Parts and Accessories

Mazda2 DJ 2014–2022 Owners Manual / Customer Information / Warranty / Add-On Non-Genuine Parts and Accessories

Please note that technical alterations to the original state of your Mazda vehicle can affect the safety of the vehicle. Such technical alterations include not only the use of unsuitable spare parts, but also accessories, fi ttings or attachments, including rims and tyres.

Genuine Mazda Parts and Genuine Mazda Accessories have been specifi cally designed for Mazda vehicles.

Other parts and accessories than those mentioned above have not been examined and approved by Mazda unless explicitly stated by Mazda. We cannot certify the suitability of such products. Mazda is not liable for any damage caused by the use of such products.

WARNING

Be very careful in choosing and installing add-on electrical equipment, such as mobile telephones, two-way radios, stereo systems, and car alarm systems: Incorrectly choosing or installing improper add-on equipment or choosing an improper installer is dangerous. Essential systems could be damaged, causing engine stalling, air-bag (SRS) activation, ABS/TCS/DSC inactivation, or a fi re in the vehicle.

Mazda assumes no responsibility for death, injury, or expenses that may result from the installation of add-on non-genuine parts or accessories.

READ NEXT:

 Cell Phones

Cell Phones Warning WARNING Please comply with the legal regulations concerning the use of communication equipment in vehicles in your country: Use of any electrical devices such as cell phones,

 Recording of Vehicle Data

This vehicle is equipped with a computer which records the following main vehicle data related to vehicle controls, operation, and other driving conditions. Recorded data Vehicle conditions su

 Declaration of Conformity

Keyless Entry System/Immobilizer System Blind Spot Monitoring (BSM) System Bluetooth ® Hands-Free Type A/Type B Type C/Type D

SEE MORE:

 Charging System

CHARGING SYSTEM LOCATION INDEX Generator (See GENERATOR REMOVAL/INSTALLATION) (See GENERATOR INSPECTION) (See GENERATOR DISASSEMBLY/ASSEMBLY) Battery (See BATTERY REMOVAL/INSTALLATION) (See BATTERY INSPECTION) (See BATTERY RECHARGING) BATTERY REMOVAL/INSTALLATION 1. Remove i

 Manifold Absolute Pressure (MAP) Sensor

MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REMOVAL/INSTALLATION 1. Disconnect the negative battery cable. 2. Remove the fresh-air duct and the air cleaner as a single unit. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION). 3. Disconnect the MAP sensor connector. 4. Remove the MAP sensor 5. Install in

© 2016-2022 Copyright www.m2info.net