Mazda 2: Accessory Sockets

Only use genuine Mazda accessories or the equivalent requiring no greater than 120 W (DC 12 V, 10 A).

The ignition must be switched to ACC or ON.

Type A

Type A


Type B

Type B


CAUTION

To prevent accessory socket damage or electrical failure, pay attention to the following:

Noise may occur on the audio playback depending on the device connected to the accessory socket

Depending on the device connected to the accessory socket, the vehicle's electrical system may be affected, which could cause the warning light to illuminate. Disconnect the connected device and make sure that the problem is resolved. If the problem is resolved, disconnect the device from the socket and switch the ignition off. If the problem is not resolved, consult an expert repairer, we recommend an Authorised Mazda Repairer.

NOTE

To prevent discharging of the battery, do not use the socket for long periods with the engine off or idling.

READ NEXT:

 Cup Holder

WARNING Never use a cup holder to hold hot liquids while the vehicle is moving: Using a cup holder to hold hot liquids while the vehicle is moving is dangerous. If the contents spill, you could

 Bottle Holder

Bottle holders are on the inside of the front doors. CAUTION Do not use the bottle holders for containers without caps. The contents may spill when the door is opened or closed.

 Storage Compartments

WARNING Keep storage boxes closed when driving: Driving with the storage boxes open is dangerous. To reduce the possibility of injury in an accident or a sudden stop, keep the storage boxes clos

SEE MORE:

 Knock Sensor (KS)

KNOCK SENSOR (KS) REMOVAL/INSTALLATION 1. Disconnect the negative battery cable. 2. Remove the intake manifold. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION). 3. Disconnect the KS connector. 4. Remove the KS using the SST 5. Install in the reverse order of removal. KNOCK SENSOR (KS) INSPECTION 1.

 Fuel Tank Pressure Sensor

FUEL TANK PRESSURE SENSOR REMOVAL/INSTALLATION CAUTION: The fuel tank pressure sensor cannot be removed as a single unit. When replacing the fuel tank pressure sensor, replace it together with the evaporative hose component as a single unit. 1. Disconnect the negative battery cable. 2. Dis

© 2016-2020 Copyright www.m2info.net